Load – Pressure
The Concrete Surface Mounted Strain Gauge is used for measuring strain in concrete structures including load bearing concrete beams and piles.
-
P8 Vibrating Wire Jack Out Pressure Cell
The Vibrating Wire Jack Out Pressure Cells are used to measure pressures on diaphragm walls during excavation.
-
Strain Gauge Load Cell
Strain Gauge Load Cells are ideally suited for measuring loads in rock bolts, cable anchors and tendons, structural beams, piles, loads between tunnel supports and loads in pull-out tests on trial anchors.
-
Vibrating Wire Concrete Stress Cell
The Vibrating Wire Concrete Stress Cell is used for measuring total stresses in tunneling process, mass concreting and rock walls in underground works.
-
Vibrating Wire Load Cell
Vibrating Wire Load Cells are ideally suited for measuring loads in rock bolts, cable anchors and tendons, structural beams, piles, loads between tunnel supports and loads in pull-out tests on trial anchors.
-
Vibrating Wire Pressure Cell
Vibrating Wire Pressure Cells measure total stresses in soils and is a combination of effective stress and pore-water pressures.
-
Vibrating Wire Push-In Pressure Cell
The Vibrating Wire Push-In Pressure Cell is normally installed in vertical boreholes and measures total horizontal stresses.